Disassembly Of The Generator Cover - Ducati Diavel Workshop Manual

Flywheel - alternator
Turn the tool shaft slowly to separate the cover (13) from the LH crankcase half.
There is a seal (4) on the cover (13) in correspondence with the gearchange lever shaft that may be damaged when
removing the generator cover.
Always check the condition of this sealing ring and renew it if damaged.

Disassembly of the generator cover

Undo the three stator retaining screws (25) and the two retaining screws (9) of the two cable grommet bracket (10) from
inside the generator cover.
Remove the stator (2) and the cable grommet bracket (10).
The generator-side crankcase cover is fitted with a bearing (27), held in place by circlip (23), which is located on the end
of the crankshaft.
Remove the circlip (23) with circlip pliers.
Remove the bearing (27) using a universal puller.
Be careful when fitting the new bearing (27) to ensure it is positioned with the shielded side facing away from the cover.
Secure the bearing with the circlip (23), ensuring that it is correctly fitted in its seat in the generator cover (13).