Refitting The External Components - Ducati Diavel Workshop Manual

Hide thumbs Also See for Diavel:

Table of Contents

Crankcase assembly: external components

To remove the engine sensor (23), unscrew the screw (25) and recover the washer (26).

Check the condition of O-rings (22) and renew them if necessary.

Loosen the clutch fluid flow rate adjusting valve (36) and remove the washer (37), the spring (38), the cap (39) and the

Refitting the external components

Fit the cap (39) on spring (38) until it engages.

Mount ball (40), spring (38) with cap (39), washer (37) and screw (36) on the chain side half-casing by starting the

screw into hole (F).

The spring (38), with cap (39), must be oriented as shown.

Tighten the screw fully home to a torque of 10 Nm (Min. 9 Nm - Max. 11 Nm).

Table of Contents

Diavel carbon