Ducati Diavel Workshop Manual page 530

Frame inspection
Place the clips (26) on the tabs (J), fix them starting the screws (25) and tighten the screws to the torque of 2 Nm ± 10%
(Sect. 3 - 3, Frame torque settings).
Position the nut (37) in the suitable seat on the compartment (23).
Fit the Immobilizer antenna (36) as shown and tighten the screw (35) on nut (37) to the torque of 2 Nm ± 10% (Sect. 3
- 3, Frame torque settings).
Fix the immobilizer antenna wire to the compartment using the three self-locking tie wraps.
Start the screw (29) on the pin (21).
Place the tank supporting pad (28) in its seat on the gloves compartment (23) and insert the pin until bringing the screw
(29) you started before fully home against the compartment (23).
Start the other screw (29) on the free end of the pin (21) and tighten the screw to a torque of 10 Nm ± 10% (Sect. 3 - 3,
Frame torque settings) holding the screw (29) on the opposite side.