Removal Of The Tool Tray - Ducati Diavel Workshop Manual

Frame inspection
motor/solenoid cable
Remove the support of the battery
and of the electrical components
Remove the exhaust unit
Remove the side stand
Remove the footrests
Bleed the lubrication system
Remove the oil pipes of the oil
radiator from the engine block
Empty the coolant out of the
cooling system
Remove the water radiators
Remove the gearchange control
Remove the clutch transmission
unit
Remove the front sprocket
Remove the rear brake control and
the rear braking system
Remove the rear wheel
Remove the rear shock absorber
support from the engine block
Remove the rear swingarm
Remove the number plate holder
Disconnect wiring connectors on the
frame
Refitting is the reverse of removal.

Removal of the tool tray

To remove the tool tray unit from the lateral footrests, loosen the screws (40) and remove the splashguard (20).
Undo the screws (15) and remove the cover (16).
5 - 6, Removing the electrical
components support
8 - 8, Removal of the exhaust
system
7 - 16, Removing of the side stand
7 - 15, Removal of the front
footrests
4 - 3, Changing the engine oil and
filter cartridge
9 - 2.2, Removal of the lubrication
system
4 - 3, Changing the coolant
9 - 3.2, Removing the water
radiators
7 - 9, Removal of the gearchange
control
7 - 8.2, Removal of the clutch
transmission unit
7 - 14, Removing of the front
sprocket
7 - 4, Removing of the rear brake
control
7 - 2, Removing of the rear wheel
7 - 12, Rear suspension system
7 - 13, Removal of the swingarm
7 - 18, Removal of the licence plate
holder
6 - 1, Routing of wiring on frame