Ducati Diavel Workshop Manual page 518

Stands
Inspecting the side stand
Fit the side stand leg to the bracket and check that there is no excessive clearance. Ensure that the ends of the side stand
are not bent with respect to the shank.
A side stand which shows signs of cracking must be renewed immediately.
To check the switch (2) refer to Sec. 6 - 6, Checking the side stand switch.
Reassembling of the side stand
Insert the side stand (1), properly greased, in the bracket (4) and fix it with the pivot (9) and the nut (8).
Tighten the nut (8) to the torque of 20 Nm ± 10% (Sect. 3 - 3, Frame torque settings).
Position the side stand return springs (6) and (7) and fix them to the fasteners (A) and (B) on the bracket and on the
stand.
Set switch (2) to plate (4) by inserting sensor pin (C) into side stand hole (D) and making sure side stand pin (E)
matches with groove (F) on sensor.