Replacing The Rear Phonic Wheel Sensor - Ducati Diavel Workshop Manual

System components
Refit the front wheel as indicated in Sect. 7 - 1,
Connect the connector (A) to the main wiring.
Restore all the retainer clamps of the front ABS sensor cable (2): refer to table of Sect. 7 - 6,
positioning.
Check the air gap between the front ABS sensor (2) and the front phonic wheel (B) as indicated in Sect. 7 - 7,
of the AIR-GAP phonic wheel
Tighten the screw (1) to the torque of 10 Nm ± 10% (Sect. 3 - 3,

Replacing the rear phonic wheel sensor

Operations
Remove the rear mudguard
Remove the silencer
Remove the rear wheel
Disconnect the rear ABS sensor (5) connector (C) from the main electric wiring.
Open all the retainer clamps of the rear ABS sensor cable (5): refer to table of Sect. 7 - 6,
positioning.
Refitting the front
sensor.
Section reference
5 - 4, Removal of the front
mudguard
8 - 8, Removal of the exhaust
system
7 - 2, Removing of the rear wheel
wheel.
Frame torque settings).
Flexible wiring/hoses
Adjusting
Flexible wiring/hoses