Gearchange mechanism
seals (5).
Loosen and remove the screw (7) securing the gearchange lever (8) to the gear selector shaft.
Withdraw the lever (8) complete with the gearchange control assembly.
Note
Mark the position of lever (8) relative to the gear selector shaft.
To remove the lever (8) from the gearchange assembly, remove the screw (10) and slide the lever (8) out.
Disassembly of the gearchange mechanism
Refer to the exploded view at the beginning of this section for indications on disassembly and renewal of gearchange
components.
If the bushing (2) inside the pedal (1) needs replacing, grease the external surface and drive the new bushing into place
using a press. The bushing must be seated 2 mm below the outer face of the pedal.
Warning
After working on the gearchange control, check the position of the gearchange pedal.
To adjust the gearchange pedal position, follow the instructions indicated in Sec. 4 - 3,
change and rear brake
Refitting the gearchange mechanism
Make sure that the gearchange linkage assembly (6) is installed with the ball joint with a left-hand thread (A) facing the
lever (8).
Apply the recommended grease to the non-threaded surface of the pin (4).
Fit the first O-ring (5) in the pin (4).
Start the pin (4) in the gearchange lever (1). Smear recommended grease on the second O-ring (5). Insert the second O-
pedals.
Adjusting the position of the gear