Tail light - number plate holder
Important
Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in
the exploded view diagram.
Removal of the licence plate holder
Operations
Remove the rear wheel
Disconnect connector (5) of the number plate holder wiring from the main one.
Release the number plate holder light cable from the ties and the cable grommets as indicated in Sect- 7 - 6,
wiring/hoses
positioning, since the cable is together with the rear ABS sensor cable.
Undo the screws (11) and remove the number plate holder assembly (9) from the swingarm.
Refitting the number plate holder
Place the number plate light (5), as indicated, on the number plate holder plate (8) and tighten the screws (7) to a torque
of 2 Nm ± 10% (Sect. 3 - 3,
Thread the number plate light wiring (C) into the opening in the number plate holder plate as shown.
Section reference
7 - 2,
Removing of the rear wheel
Frame torque
settings).
Flexible