Ducati Diavel Workshop Manual page 382

Front wheel
Tighten the nut (1) to the torque of 63 Nm ± 5% (Sect. 3 - 3, Frame torque settings).
Grease the threads and undersides of the heads of screws (A).
Tighten the two retaining screws (A) of the brake callipers (B) to a torque of 2 Nm ± 10%. (Sect. 3 - 3, Frame torque
settings)
Operate the front brake lever two or three times.
Hold the lever pulled towards the handgrip and simultaneously tighten the screws (A) to a torque of 44 Nm ± 5%(Sect. 3
- 3, Frame torque settings).
Before tightening the screws (8), lower the bike to the ground and push up and down on the handlebar to load the
suspension; so the fork legs will become properly seated onto the wheel shaft.
Tighten the screws (8) to a torque of 10 Nm ± 5% (Sect. 3 - 3, Frame torque settings), proceeding in a 1-2-1 sequence.