Front and rear mudguard
Place the hose grommet (A) of the front brake hose and the speed sensor cable inside clip (4) as shown in the figure.
Frame torque
settings).
Close the clip (4) and tighten the screw (7) to a torque of 0.35 Nm ± 10% (Sect. 3 - 3,
Removing the rear mudguard
Undo the screws (9) and remove the rear mudguard (8) from the swingarm.
Refitting the rear mudguard
Place the rear mudguard (8) on the swingarm, fitting the screws (9) with recommended threadlocker.
The screw (9) in the bottom hole of the rear mudguard (8) must be installed with the washer (R).
Tighten the screws (9) to a torque of 5 Nm ± 10% (Sect. 3 - 3,
Frame torque
settings).