BBS and DB faults
PIN numbering for wiring harness side dashboard connector.
Number plate light not working
Fault codes
DDS: no fault code displayed.
Dashboard: no fault code displayed.
Location of connections and components
Location of rear turn indicator and number plate light connection.
PIN numbering for wiring harness side dashboard connector.
Checks
The number plate light receives PWM power supply from the dashboard. If necessary, power the number plate light with a
12 V external power supply to test function (connect correctly as indicated in the wiring diagram).
Check congruence of the ground connection on the number plate light.
Check the integrity of the electrical circuit and connections (short-circuits to ground, short-circuits to Vdc, open circuits).
If none of the aforementioned tests identifies the problem, replace the dashboard.
Note
Check integrity of electric circuit – short-circuit to Vdc = with dashboard on, using a voltmeter, a voltage is measured
between the wire tested and ground.
Check integrity of electric circuit – short-circuit to ground = with the battery cables disconnected, using an ohmmeter,
continuity is detected between the wire tested and ground.
Check integrity of electric circuit – open circuit = with the battery cables disconnected, using an ohmmeter, no continuity
is detected between the two ends of the wire tested.