Lubrication system: oil pump
Check the condition of the above components.
Remove the circlip (6) and withdraw the pump drive gear (12).
Reassembly of the oil pump
Check that the circlip (3) and tongue (13) are present on the pump.
Fit the pump drive gear (12) on to the oil pump and secure it by installing the circlip (6) in its groove.
Insert the by-pass valve pump (17), the spring (16) and screw the plug (14). Tighten the plug (14) to a torque of 17 Nm
(Min. 15 Nm - Max. 19 Nm) (Sect. 3 - 3,
Engine torque
settings) applying a medium strength threadlocker.
Refitting the oil pump
If removed, apply specific threadlocker on the bushing (7) outer thread, and screw it in the crankcase half, observing the
height.