Cylinder/piston assemblies
Fit the cylinder head gasket (11) over the studs. The side marked with the part number must be facing the cylinder head.
Note
The shape of the gasket prevents incorrect fitting, provided that the coolant flow holes are aligned with those on the
cylinder.
Repeat the procedure for the other cylinder and refit the cylinder heads (Sect. 9 - 4.5,
Refitting the cylinder head
assemblies).
In case they have not been assembled, apply prescribed threadlocker to unions (6) and tighten them to a torque of 25
Nm (Min. 23 Nm - Max. 27 Nm) (Sect. 3 - 3,
Engine torque
settings).
Fit the tubes (8) and (9) and tighten clamps (7) to a torque of 2.5 Nm (Min. 2 Nm - Max. 3 Nm) (Sect. 3 - 3,
Engine
torque
settings).