Immobilizer Override Procedure - Ducati Diavel Workshop Manual

Instruments
Note
If the disabling request was not met, it is recommended to repeat the procedure. If the problem persists, contact your
Ducati dealer or Authorised Service Centre.
To exit the setting function, press the reset button (3) when "EXIT" is highlighted.

Immobilizer override procedure

This procedure makes it possible to "temporarily" turn on the motorcycle if the HF (Hands Free) System is not working.
Note
The PIN CODE function must be activated by entering your 4 digit PIN in the dashboard, otherwise the vehicle cannot be
turned on temporarily in the case of a malfunction.
Warning
The motorcycle owner must activate (store) the PIN code; if there is already a stored PIN, contact an Authorised Ducati
dealer to have the function "reset". To perform this procedure, the Authorised Ducati Dealer may ask you to demonstrate
that you are the owner of the motorcycle.
PIN CODE activation function
To access the function it is necessary to view the "setting"menu, using buttons (1) "s" or (2) "t" to select the "PIN CODE"
function and press the reset button (3) to enter the following page.
Note
If "MODIFY PIN CODE" appears when accessing this function, this means that there is already a stored PIN and therefore
the function is already active.
When accessing the function, "INSERT NEW PIN CODE" with four dashes "- - - -" in the bottom line will appear on the
display highlighted in green; now enter a 4 digit code.
Entering the code:
press the reset button (3).
Pressing button (2) "t" repeatedly cycles the highlighted number from "0" to "9" and then back to "0";
to confirm the number, press the reset button (3).
Repeat the procedure until inserting the fourth digit.
To highlight the "MEMORY" indication, press the reset button (3) again.
To store the entered PIN, press the reset button (3) for 3 seconds with "MEMORY" indication highlighted in green.
As a confirmation of PIN storage, the display will show the message "MEMORIZED" for about 2 seconds and then
automatically highlight "EXIT" option.
From this moment, "MODIFY PIN CODE" will be displayed when accessing the "PIN CODE" function and the PIN can be