Introduction to the engine control system
Side stand button
Introduction
The side stand button is located on the side stand. Together with the signal from the clutch button and the neutral signal
generated by the gear sensor (transmitted to the engine control unit over the CAN line), the side stand position signal is
used to enable or disable engine start.
The following table indicates the only conditions in which starter motor activation and, as a result, engine start, are
permitted:
Gearbox in neutral – any side stand and clutch lever
position
Gear engaged – side stand retracted – clutch lever
pulled
If a gear is engaged with the side stand down, however, the engine switches off.
Component assembling position
The side stand button is integrated in the rotation pivot area of the side stand itself.
Location of side stand connection.
Connection wiring diagram
CCM engine control connection, S side stand button. 3 black – Bk, 2 white/black – W/Bk.
The starter motor may be operated
The starter motor may be operated