Ducati Diavel Workshop Manual page 692

Cylinder head assemblies: camshafts
Remove excess sealant from the area of application.
Repeat the same procedure for the other cylinder head.
If the screw (10) has been removed, upon reassembly apply specified threadlocker, insert the seal (28) and tighten the
screw (10) to a torque of 10 Nm (Min. 9 Nm - Max. 11 Nm) (Sect. 3 - 3,
Refit all the components removed in the procedure.
Operations
Refit the cylinder head cover
Refit the coils
Refit the exhaust unit
Fasten the timing belt covers
Reassemble the water radiators on
the frame
Tighten the clamps of the hose
that connects the two radiators
and the hose that connects the RH
radiator to the union
Refill the cooling system
Refit the oil breather pipe, the
blow by, the throttle body and the
airbox
Connect the throttle cable
Refit air conveyors
Refit the fuel tank
Reassemble the tank half covers
Reassemble air conveyor covers
Refit the saddles
Section reference
9 - 4.4, Refitting the camshafts
6 - 9, Ignition coils
8 - 8, Refitting the exhaust system
9 - 4.2, Refitting the timing covers
9 - 3.2, Refitting the radiator
9 - 3.1, Removal of the cooling
system hoses and unions
4 - 3, Changing the coolant
8 - 6, Refitting the airbox and
throttle body
7 - 8.1, Refitting the throttle
twistgrip
8 - 7, Refitting the air filters
8 - 2, Refitting the fuel tank
5 - 2, Refitting the fuel tank
fairings
8 - 7, Refitting the air filters
5 - 3, Refitting the seat
Engine torque settings).