Solenoid Starter - Ducati Diavel Workshop Manual

Electric starting system
gears
Refit the starter motor idler gear
Refit the flywheel/alternator
assembly and the generator cover
Refit the water pump-radiator hose 9 - 3.2,
Refit the pump-cylinder hoses
Refill the cooling system
Fill the system with engine oil
Reassemble the left belly fairing
Reassemble the silencer and the
vertical exhaust pipe

Solenoid starter

Operations
Remove the left belly fairing
Remove the protection cover (A).
Undo the screws (2), taking care to collect the spring washers (3).
Remove the starter motor-solenoid cable (4) and the solenoid-battery cable (5).
Remove the starter solenoid (1) sliding it upwards.
Checking operation of the starter solenoid
To check the solenoid starter proceed as indicated in Sect. 6 - 8,
Ensure that the terminals are not oxidised.
Position the solenoid-starter motor cable (4) and the solenoid-battery cable (5) on the solenoid terminals.
Start the screws (2) fitting the spring washers (3).
Tighten the screws (2) to a torque of 4 Nm ± 10% (Sect. 3 - 3,
Apply waterproof spray in the area of the screws.
Fix the starter solenoid (1) to the battery support inserting it in the tongues (B).
9 - 9.1, Refitting the starter motor
gear
9 - 8, Refitting the flywheel-
alternator assembly
Refitting the radiator
9 - 5, Refitting the cylinder/piston
assembly
4 - 3, Changing the coolant
4 - 3, Changing the engine oil and
filter cartridge
5 - 5, Reassembly of belly fairing
8 - 8, Removal of the exhaust
system
Section reference
5 - 5, Removal of belly fairing
"Starter motor relay".
Frame torque settings).