Ducati Diavel Workshop Manual page 405

Rear brake
Warning
If incorrectly positioned, the hose can affect brake operation and foul moving parts. Position the hose as shown in the
figure.
Remember to fit the copper faced sealing washers (23) to the hose end fitting when reconnecting the brake pipe to the
brake calliper (15).
After orientating the fitting, lock the special screw (22) to a torque of 23 Nm ± 10% (Sect. 3 - 3,
If the speed sensor (1) was removed, fit it on the calliper holder bracket (A) with the spacer (8) and the washer (32) and
tighten the screw (2) to a torque of 10 Nm ± 10% (Sect. 3 - 3,
Note
The gap between the sensor (1) and the brake disc fixing screw must be within 0.6 to 2.2 mm.
If it is necessary to remove the calliper holder bracket (A) in order to refit it, see Sec. 7 - 13,
eccentric hub and rear wheel
Insert the rear brake calliper (15) on the brake disk, aligning it with the holes of the calliper mounting bracket (A).
Grease the screws (12) and tighten to the torque of 25 Nm ± 5% (Sect. 3 - 3,
In order to fit the pipe (33), the speed sensor (1) and the retaining clamps follow instructions in Sect. 7-6,
wiring/hoses positioning.
Operations
Fill the rear brake circuit
1
shaft.
Section reference
4 - 3, Changing the brake fluid
Frame torque settings).
Frame torque
Frame torque settings).
Refitting the rear wheel
settings).
Flexible