Possible Faults Of The Hands Free System Components; The Hands Free Module - Ducati Diavel Workshop Manual

The Hands Free system
This image shows the location of the Hands free system antenna, behind the clear Plexiglas windscreen
The Hands free relay, which ideally replaces the function of the ignition switch of the traditional bikes, supplies +15 with
key turned to on, and is positioned on its supporting bracket.
This image shows the location of the Hands free relay (A). It is located on the relay supporting bracket.

Possible faults of the Hands Free system components

The Hands Free module

Introduction
The Hands free module incorporates the control unit communicating with the other nodes on the motorcycle, the on/off
button, the microswitches detecting full lock steering angle (for enabling steering lock engagement) and the steering lock.
The module is sealed and its individual components cannot be accessed for diagnosis, repair or replacement.
Wiring diagram
No wiring diagram is available for the components integrated into the Hands free module. For the main electric wiring see
chapter ("Wiring diagram of the Hands Free
Error codes
"Hands free diagnosis" error: "Steering lock": a fault has been detected in the electric steering lock system. The following
icon appears on the tank dashboard:
- If the error occurred while engaging or disengaging the steering lock, check that the handlebar is fully turned to the left
or right and try to engage or disengage the steering lock again.
- If the error occurred while engaging or disengaging the steering lock, check that the lock pin can move freely and is
unobstructed, then try to engage or disengage the steering lock again.
- If none of the tests described above identifies the problem, replace the Hands free system.
"Hands free diagnosis" error: "EEPROM state": fault detected in the internal Hands free system memory. The following
icon appears on the tank dashboard:
system") of this section.