Ducati Diavel Workshop Manual page 412

Hide thumbs Also See for Diavel:

Table of Contents

System components

Remove the rear ABS sensor (5) from its seat on the rear calliper mounting bracket (E), undoing the retaining screw (1)

and collect the calibrated gasket (3).

Before refitting, make sure that the contact parts between the rear ABS sensor (5) and its seat are not damaged and are

perfectly clean.

Fit the new rear ABS sensor (5) on its seat inserting the screw (1).

Check the air gap between the new rear ABS sensor (5) and the rear phonic wheel (D) as indicated in Sect. 7 - 7,

Adjusting of the AIR-GAP phonic wheel

Fix the sensor to the calliper holder bracket tightening the screw (1) to a torque of 10 Nm ± 10% (Sect. 3 - 3,

Connect the connector (C) to the main wiring.

Restore all the retainer clamps of the rear ABS sensor cable (5): refer to table of Sect. 7 - 6,

Flexible wiring/hoses

positioning.

Section reference

Chapters

Table of Contents

Diavel carbon