Refitting The Front Brake Master Cylinder; Maintenance Operations - Ducati Diavel Workshop Manual

Front brake control
For disassembly of components of the master cylinder assembly (1), refer to the exploded view at the beginning of this
chapter.

Refitting the front brake master cylinder

Insert the front brake master cylinder unit (1) on the right side of the handlebar to bring the terminal internal edge in
correspondence to the bolted joints (A).
Fit the terminal (12) on the handlebar inserting the screws (15).
Tighten the terminal (12) retaining screws to a torque of 10 Nm ± 10% (Sect. 3 - 3,
sequence 1-2-1 starting from the upper screw.
Locate the pipe with sealing washers (4) on the master cylinder assembly (1) and secure it with the special screw (3),
without tightening it.
Warning
An incorrectly positioned hose can cause clutch faults and interfere with moving parts.
Orientate the pipe (24) as illustrated in the figure and then tighten the special screw (3) to a torque of 23 Nm ± 10%
(Sect. 3 - 3, Frame torque
In order to fit the pipe (24) and the retaining clips, follow instructions in Sect. 7 - 6,
Operations
Refit the rear-view mirrors
Fill the brake circuit

Maintenance operations

settings).
Section reference
5 - 1, Refitting the rear-view mirrors
4 - 3, Changing the brake fluid
Frame torque settings) following the
Flexible wiring/hoses positioning.