Airbox – Throttle Body
- on the opening throttle cable is a white writing;
- on the closure throttle cable is a yellow writing.
Insert the bolts (T) in the corresponding seats of the pulley. Keep oriented as shown in figure, fasten the cables (M) and
(H) inserting the nuts (L).
Tighten the nuts (L) to a torque of 2.5 Nm ± 10% (Sect. 3 - 3,
Frame torque
settings).
Fit the dust caps (V) on the throttle cable sheaths terminals.
Check that the clip (21) of hose (26) is positioned as shown.
Refitting the airbox and throttle body
Position the filter box (1).
Operate on the vehicle LH side, connect connector (F) of the TPS/DIV motor.
Operating on the right side of the vehicle, connect connector (E) from the APS sensor.