Removal Of The Clutch Transmission Unit; Refitting The Clutch Transmission Unit - Ducati Diavel Workshop Manual

Handlebar unit: Hydraulic clutch control
Refit the LH mirror
Fill the clutch circuit

Removal of the clutch transmission unit

Warning
The manufacturer of the clutch transmission unit (15) advises against servicing of its internal parts due to the safety-
critical nature of this component.
Incorrect overhaul of these critical safety components can endanger rider and passenger safety.
The only components that should be renewed are the complete clutch transmission unit, the bleed valve, the seals and
the complete clutch pushrod assembly.
Operations
Drain the clutch system
Undo the screws (11) and slide out the clutch slave cylinder (R).
Remove the dust gaiter (16) and the bleed valve (17) and unscrew the screw (18), taking care to recover the gaskets
(19): the unit (R) is now disconnected from the pipe (4).
Push in the piston to force out all the fluid from inside the cap.
At this point, it is possible to slide also the clutch gear rod (14).

Refitting the clutch transmission unit

Position pipe (4) on the clutch slave cylinder (R).
5 - 1, Refitting the rear-view mirrors
4 - 3, Filling the clutch circuit
Section reference
4 - 3, Draining the clutch hydraulic
circuit