Removal Of The Starter Motor Idler Gear - Ducati Diavel Workshop Manual

Crankcase assembly: external components
Refill the cooling system
Refit the gearchange control
Refit the clutch control piston
Refit the sprocket cover
Refill the system with engine oil

Removal of the starter motor idler gear

Operations
Drain the engine oil
Remove the front sprocket cover
Remove the clutch pushrod
Remove the gearchange control
Empty the coolant out of the
cooling system
Remove the pump-cylinder hoses
Remove the water pump-LH water
radiator hose
Remove the generator cover and
flywheel-generator assembly
Slide the gear pin (21) complete with the gear (19) and washer (20).
Warning
Pay attention to the washer (20) since it may fall inside the crankcase half.
At this point, it is possible to remove the starter motor as described in Sect. 6 - 3,
Refitting the starter motor gear
4 - 3, Changing the coolant
7 - 9, Refitting the gearchange
mechanism
7 - 8.2, Refitting the clutch
transmission unit
7 -14, Refitting the front sprocket
4 - 3, Changing the engine oil and
filter cartridge
Section reference
4 - 3, Changing the engine oil and
filter cartridge
7 -14, Removing of the front
sprocket
7 - 8.2, Removal of the clutch
transmission unit
7 - 9, Removal of the gearchange
control
4 - 3, Changing the coolant
9 - 5, Removal of the
cylinder/piston assembly
9 - 3.1, Removal of the cooling
system hoses and unions
9 - 8, Removal of the generator
cover
Starter motor.