Reassembly Of The Tool Tray - Ducati Diavel Workshop Manual

Frame inspection

Reassembly of the tool tray

Place the tool tray unit (23) on the lateral brackets (2) and (3) by tightening the screws (24) to 14 Nm ± 5% (Sect. 3-3,
Frame torque settings).
If the handle guide (32) has been previously removed, position it on the tray (23) and tighten the screws (34) to 20 Nm
± 5% (Sect. 3-3, Frame torque settings).
Reposition the wiring branch in the seat (S) in the tray (23).
Place the gloves compartment cover (16) on gloves compartment (23), inserting wiring (C) into the suitable recess in the
cover (16).
Warning
While positioning the cover (16) on the compartment (23), push bracket (E) of the lock latch (D) in the direction shown by
the arrow, to prevent the lock wire terminal (H) from being squeezed under the cover.