Removal Of The Front Brake System - Ducati Diavel Workshop Manual

Hide thumbs Also See for Diavel:

Table of Contents

Front brake control

Brake fluid is corrosive and will damage paintwork. Avoid contact with eyes and skin. In case of accidental contact, wash

the affected area with abundant running water and consult a doctor if necessary.

For all the maintenance operations (wear check and replacement of brake pads and brake fluids, etc.) see Sect. 4 - 3,

Removal of the front brake system

Empty the front braking system

For the ABS front braking system, also refer to Sect. 7 - 5,

components, Sect. 7 - 7,

Undo the special screw (3), collect the sealing washers (4), and release the front brake master cylinder assembly (1) from

Tighten the screw (16) and slide the front brake pipe (13) from the bracket (17) on the yoke base.

Loosen screw (C) to remove front brake hose (20) and the ABS sensor cable (A) from hose clip (B).

While removing the front brake hose, if you damage the hose clip (B) you shall renew it (Sect. 5 - 4,

If hose is not fastened by hose clip (B), it might interfere with tyre under braking and provoke accidents.

Section reference

Changing the brake fluid

ABS components

maintenance.

ABS system operating

information, Sect. 7 - 6,

Removal of the front

Table of Contents

Diavel carbon