Ducati Diavel Workshop Manual page 104

Fairings
Fit the tank RH fairing (13) and keep it in position by starting the screws (16) together with the relevant washers (17).
Apply some threadlocker on the screw (14), fit the nylon washer (15) and start the screw.
Tighten the screw (14) to a torque of 2 Nm ± 10% (Sect. 3 - 3, Frame torque settings) and the screws (16) to a torque
of 0.33 Nm ±10% (Sect. 3 - 3, Frame torque settings).
Fit the vibration dampers (G) to the master dashboard (F).
Insert the spacers with collar (J) onto the vibration dampers (G).
Fit the vibration damper (20) to the tank plug cover (23) at the position shown.
Important
On refitting, make sure that the vibration damper (20) is fully in place.
Fit the master dashboard (F) on the tank plug cover (23) inserting tab (L) into the vibration damper (20).
Fix the master dashboard (F) to the cover (23) by tightening the screws (M) to a torque of 2 Nm ± 10% (Sect. 3 - 3,
Frame torque settings).