Disassembly Of The Rear Brake Control - Ducati SUPERBIKE 848 MY 2008 Manual

Rear brake control
Remove the brake fluid reservoir (26) complete with the hose (21) from the frame by unscrewing the bolt (24).
Remove the complete rear brake control.

Disassembly of the rear brake control

The brake master cylinder is supplied only as a complete unit; internal components cannot be replaced.
To disassemble the master cylinder's outer parts, follow the indications given in the exploded view at the beginning of
this section.
If the bush (10) inside the brake pedal (6) needs replacing, drive the replacement bush into place using a press. The
bush must be seated 2 mm below the pedal's outer face.
To disassemble the various parts of the system, refer to the exploded view at the beginning of this chapter.
Warning
After working on the rear brake control, check the operation of the brake pedal followingthe instructions given in
Sect. D 4, Adjusting the position of the gearchange and rear brake
file:///C|/848/wsm/en/848_08_F_04_6_00.29.1.html (3 of 4) [11-6-2008 0:34:28]
WWW.PlanDeGraissage.ORG
pedals.