Removing Of The Rear Brake Control - Ducati Diavel Workshop Manual

Rear brake
33 Control unit - rear calliper pipe
34 Cable grommet
35 Fluid reservoir assembly
36 Plug
37 Screw
38 Support
39 Spacer
40 Screw
41 Pair of brake pads
42 Spare clip pins
43 Clip spring
44 Boot
45 Bleed valve
46 Dust cap
Spare parts catalogue
Diavel ABS
REAR BRAKE
Diavel ABS
ANTILOCK BRAKING SYSTEM (ABS)
Diavel ABS
REAR WHEEL AXLE
Diavel Carbon
REAR BRAKE
ABS
Diavel Carbon
ANTILOCK BRAKING SYSTEM (ABS)
ABS
Diavel Carbon
REAR WHEEL AXLE
ABS
Important
Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in
the exploded view diagram.

Removing of the rear brake control

Warning
The brake master cylinder manufacturer advises against servicing the brake master cylinder due to the safety critical
nature of this component.
Incorrect overhaul can endanger the rider and passenger.
Maintenance operations on these units are limited to renewal of the following parts: control lever, fluid reservoir assembly
and relative fasteners and master cylinder fasteners.
Operations
Empty the rear braking system
Disconnect the rear stop switch
from the main wiring
Remove the RH footrest bracket
Note
For the ABS front braking system, also refer to Sect. 7 - 5,
components, Sect. 7 - 7,
Slide the adjusting rod (18) out of the rear brake master cylinder (16).
Section reference
4 - 3, Changing the brake fluid
6 - 1, Routing of wiring on frame
7 - 15, Removing of the rear
footrests
ABS components maintenance.
ABS system operating information, Sect. 7 - 6, System