Reassembling The Frame And The Lateral Footrests - Ducati Diavel Workshop Manual

Frame inspection
Fit the blackbox cover (S) starting the screws (U) and tighten the screws (U) to the torque of 3 Nm ± 10% (Sect. 3 - 3,
Frame torque settings).

Reassembling the frame and the lateral footrests

Apply the recommended grease to the thread of the pins (9) and of the nuts (8).
Place the frame (1) and the brackets (2) and (3) on the engine block. Start the pins (9) by holding the nuts (8) and insert
without tightening the screws (6) into the adjusters (4).
Position and fix the rear shock absorber support to the engine crankcases and the swingarm brackets (Sect. 7 - 12,
Refitting the shock absorber support).
Tighten the screw (V) on the swingarm shaft right side to a torque of 72 Nm ± 5% (Sect. 3 - 3, Frame torque settings),
by holding the screw (Z) on the left side.
Tighten the indicated front nut (8) to a torque of 60 Nm ± 5% (Sect. 3 - 3, Frame torque settings), by holding the pin (9)
on the left side.