Active Key - Ducati Diavel Workshop Manual

The Hands Free system
This image shows the location of the Hands free relay (A). It is located on the relay supporting bracket.
Component replacement methods
No special measures are necessary in order to replace the Hands free relay.

Active key

Introduction
The active key (1) communicates with the Hands free system by radio. In order to function, the key must be within a 1.5
metre radius from the antenna (located in the document compartment under the seat).
In the event of a flat key battery or of an internal transmitter circuit fault, the active key may be used in transponder
mode (exactly like the passive key). In this mode, the key must be physically placed on the antenna in order to work
correctly.
By pressing button (A) of the active key (1) the metallic part (2) opens completely - position (B).
Hold depressed button (A) to move the metal part (2) and set it to the middle position (C); once in place, release button
to lock. This function facilitates the opening of the tank plug.
The metal part returns inside the grip by pushing it in.
Wiring diagram
No wiring diagram is available for the component
Error codes
"Key diagnosis" error: "Wrong Key". The key has been detected but is not associated with the Hands free system. The
fault can only be viewed from the DDS after switching the dashboard on with the PIN code.
- Check that the key is correct.
- Reprogramme the key
- If none of the tests described above identifies the problem, replace the Hands free system.