Check The Idle And The Co Amount With Warm Engine; Check The Engine Oil Pressure - Ducati Diavel Workshop Manual

Diagnostic instruments
Warning
Make sure that the throttle body pulley is completely against the anti-stitching screw.
Make sure that the throttle cable free play is correctly adjusted.

Check the idle and the CO amount with warm engine

1 start the engine;
2 Switch on the DDS and check that it does not signal any error (otherwise consult the relevant paragraph of this manual
to reset the error and proceed with the idle check);
3 Enter the "SELF DIAGNOSIS" menu by selecting the DIAVEL model in the available vehicle version. Enter the "ENGINE
ELECTRONICS" system and check the default parameters.
See list below:
A RPM
B Engine temperature
C Air temperature
D Throttle valve aperture
E MAP1 pressure sensor
F MAP2 pressure sensor
4 Wait for the engine temperature to exceed 80 °C displayed on the DDS, and then adjust only the by-pass screw of the
vertical cylinder until the "MAP2 pressure sensor" parameter displayed on the DDS is nearly -52KPa;
5 make sure that the system automatically keeps the idle between 1350 +- 100 rpm; in case the idle is too high check
for no cuts in the pressure sensor wires, cracks or cuts in the intake manifolds, make sure that the latter are well fixed
to the engine, and so on.
6 wait that the engine temperature exceeds 90°C displayed on the DDS; if the air temperature detected by the DDS
ranges between 19 °C and 40 °C the CO in these engine temperature conditions must be within 0.4% and 2% on both
cylinders; if this check is not successful try to replace the lambda sensor of the faulty cylinder and, in case the problem
still occurs, inspect the faulty cylinder (clearance, strokes, valve sealing, etc.).
Warning
If the engine is shut off during the CO level check, wait three minutes after starting for the after-starting enrichment
phase to be finished and the lambda sensors to start operating.

Check the engine oil pressure

Note
The on-screen icons used during this procedure are explained in a table at the end of this section.
To measure the pressure of the lubrication circuit, use the engine oil pressure test point (19) as described below.
Operations
Remove the right belly fairing
Disconnect the wiring connector (F) of pressure switch (1) and remove it taking care to recover the seal.
Section reference
5 - 5, Removal of belly fairing