Alternator - Ducati Diavel Workshop Manual

Battery charging system
Place the battery (3) on its support, then position the retaining bracket (2) and tighten the screws (1) to a torque of 10
Nm ± 10% (Sect. 3 - 3,
Operations
Reassemble the left belly fairing 5 - 5,

Alternator

It is equipped with a 12 V, 430 W generator, consisting of a fixed element (stator, A) located on the generator cover and
of a movable element (rotor, B) fixed to the crankshaft.
Note
To check the battery charging system for faults, use the DDS diagnosis instrument and follow the instructions given in the
paragraph, "Testing the battery charging
The absolute value of voltage measured across the terminals of two of the three yellow cables (the measured value will be
the same whichever combination of cable is used) must be within the range indicated in the table below.
(Ambient temperature: 35 °C - 70 °C)
Important
Before testing, disconnect the alternator wiring from the electrical system when the ignition key is set to OFF.
Frame torque settings).
Section reference
Reassembly of belly fairing
system" (Sect. 6 - 11).