Ducati Diavel Workshop Manual page 482

Rear shock absorber assembly
Start the adjuster (36) and tighten it manually (y is equal to about 2 threads) on the external side of the plate of the side
stand assembly (G).
Note
During this operation, be sure to keep ring nut (3) in position, i.e. flush with the external surface of the clearance adjuster
(36).
Apply the recommended grease to the threads and undersides of the heads of the screws (L) and (H).
Position the shock absorber support (19) and the side stand assembly (G) on the left-hand side of the engine and start
the screws (L) and (H).
Insert a suitable centring pin (U1) on the adjuster (36), making sure that the pin hexagon fits properly into the hexagon
socket of the adjuster.
Insert the bush (6) to keep the components in place.
On the right side, insert a suitable centring pin (U2) on the front adjuster (4) and a suitable centring pin (U3) on the rear
adjuster (4), making sure that the pin hexagons fit properly into the hexagon sockets of the adjusters.