Ducati Diavel Workshop Manual page 695

Cylinder head assemblies: camshafts
Check that the mating surfaces of the cylinder head and manifold are perfectly flat and clean and install the intake
manifold (25) on the cylinder head.
Lock the fixing screws (21) to the torque of 10 Nm (Min. 9 Nm - Max. 11 Nm) (Sect. 3 - 3,
cross-pattern sequence (1-2-3-4).
Operations
Refit the water expansion reservoir 9 - 3.1,
Refill the cooling system
Refit the injectors on the intake
manifolds and reassemble the
supply system
Refit the oil breather pipe, the blow
by, the throttle body and the airbox
Connect the throttle cable
Refit air conveyors
Refit the fuel tank
Reassemble the tank half covers
Reassemble air conveyor covers
Refit the saddles
1
Section reference
Refitting the expansion
tank
4 - 3, Changing the coolant
8 - 6, Refitting the injectors
8 - 6, Refitting the airbox and
throttle body
7 - 8.1, Refitting the throttle
twistgrip
Refitting the air filters
8 - 7,
8 - 2, Refitting the fuel tank
5 - 2, Refitting the fuel tank fairings
8 - 7, Refitting the air filters
5 - 3, Refitting the seat
Engine torque settings) in a