Ducati Diavel Workshop Manual page 564

Airbox – Throttle Body
If removed, refit the intake ducts (14) on throttle body (4) and apply prescribed threadlocker to the screws (5) and
tighten them to a torque of 3.5 Nm ± 10% (Sect. 3 - 3,
Important
After tightening, visually check that the seals (15), previously fitted on the intake funnels, are still in their seats, and that
the intake funnels are perfectly coupled with the throttle body.
Fasten the throttle body (4) to the airbox (1).
Position and tighten the fixing screws (16) and tighten them to the torque of 5 Nm ± 10% (Sect. 3 - 3,
settings), following the sequence indicated in figure.
If removed, refit the throttle grip cable as indicated: insert the opening cable (M) and the closing cable (H) in the
corresponding plate seats (W) on the throttle body (4) as shown in figure.
Note
The throttle cables are distinguished by the writings in different colours on them:
Frame torque settings) following the sequence indicated in figure.
Frame torque