Overhauling The Front Wheel - Ducati Diavel Workshop Manual

Front wheel

Overhauling the front wheel

Wheel bearings
Before checking the dimensions, check the wear on wheel bearings. Check for wear by hand after cleaning and degreasing
the bearings in their seats.
Turn the inner race.
Check the amount of radial and axial play. Excessive play will cause vibration and make the bike unstable.
To remove the bearings (5) and the sealing rings (4) from the wheel hub follow the instructions below.
Position a drift (A) against the inner race of the bearing (5).
Tap with a hammer until knocking out the bearing (5).
Apply the drift at different points to keep the bearing square during removal.
Important
Once removed, the used bearings and sealing rings must not be refitted.
Before fitting new bearings, check that the housing is clean and free from scoring and damage.
Grease the bearing seat and then push the new bearing into its seat.
Using a tubular drift (B) that only bears on the outer race of the bearing, drive the bearing (5) fully into its seat.
Use the same method to install the sealing rings (4).
Ensure that spacer (7) is fitted between the two wheel bearings.