Ducati Diavel Workshop Manual page 496

Hide thumbs Also See for Diavel:

Table of Contents

To change the bearings, proceed as follows.

Remove the shims (12) and (9) from the right-hand side of the swingarm (8) and refit the bush (4) from the left-hand

Remove the ball bearings (10), sealing rings (5) and roller bearings (6) with a suitable punch and press. Support the

swingarm and take care not to damage the bearing bores.

Once removed, the bearings (10), sealing rings (5) and roller bearings (6) must not be reinstalled.

Heat the entire swingarm up to 150 °C while supporting its weight adequately.

Apply recommended grease to the swingarm bearings seat.

Upon reassembly the seals (5) must be oriented so that the plane side is faced outwards and the writings on the roller

bearings (6) must be faced up.

Chapters

Table of Contents

Diavel carbon