Crankcase assembly: crankcase halves
Bring the crankcase halves (3) and (13) together, tapping with a rubber mallet in the area of the shafts if necessary.
Apply the recommended grease to the screws and insert them in the crankcase halves (note that the screws are different
lengths). Start with the larger diameter screws (M8), and follow the order indicated.
Ref.
Qty
12
4
25
3
24
8
27
2
Tighten all screws to the torque indicated below (Sect. 3 - 3,
- screws (12) and (25) to a preload of 19 Nm (Min. 17 Nm - Max. 21 Nm) and then a torque of 25 Nm (Min. 22 Nm - Max.
28 Nm);
- screws (24) and (27) to a torque of 10 Nm (Min. 9 Nm - Max. 11 Nm).
Description
M8x90 mm screws
M8x75 mm screws
M6x35 mm screws
M6x75 mm screws
Engine torque
settings):