Removal Of The Clutch Master Cylinder Assembly; Refitting The Clutch Master Cylinder Assembly - Ducati Diavel Workshop Manual

Handlebar unit: Hydraulic clutch control
Diavel ABS
CLUTCH
Diavel Carbon
CLUTCH CONTROL
ABS
Diavel Carbon
CLUTCH
ABS
Important
Bold reference numbers in this section identify parts not shown in the figures alongside the text, but which can be found in
the exploded view diagram.

Removal of the clutch master cylinder assembly

Warning
The clutch master cylinder manufacturer advises against servicing of the clutch master cylinder (1) due to the safety-
critical nature of this component. Incorrect overhaul of this component could endanger rider safety.
Maintenance operations of the master cylinder are limited to replacing the following parts: control lever, reservoir unit,
and master cylinder fasteners.
Operations
Drain the clutch system
Remove the LH mirror
Loosen the special screw (1) by collecting the seals (2), to release the clutch master cylinder assembly (3) from the clutch
control pipe (4).
Undo the fixing screws (V) of the mounting U-bolt (6) and then remove the clutch master cylinder unit (3) from the
handlebar.
Refer to the exploded view at the beginning of this section for indications on disassembly and replacement of the master
cylinder components.

Refitting the clutch master cylinder assembly

Insert the clutch master cylinder assembly (3) and the clamp (6) on the left handlebar, so that the top mating faces
match the mark (Z) on the handlebar as shown.
Section reference
4 - 3, Draining the clutch hydraulic
circuit
5 - 1, Removal of the rear-view
mirrors