How To Enable Engine Start With Pin Code; How To Enable The Pin Code; How To Reset The Pin Code; Wiring Diagram Of The Hands Free System - Ducati Diavel Workshop Manual

The Hands Free system
Once vehicle speed exceeds 5 Km/h after starting the motorcycle with the PIN code, the no key message is displayed on
the dashboard. This is normal.
After switching both the engine and the dashboards off, the PIN code entry procedure has to be repeated in order to use
the motorcycle again.

How to enable engine start with PIN code

See the paragraph relevant to the dashboard for entering and using the PIN codeImmobilizer override procedure in Sect.
6 - 7.

How to enable the PIN code

See the paragraph relevant to the dashboard for enabling the PIN codeImmobilizer override procedure in Sect. 6 - 7.

How to reset the PIN code

The Pin Code can be reset with the DDS, i.e. it can be brought to the same condition it was in when the bike came out
the factory. It is possible to complete the procedure with the relevant Pin Code Reset function.
Once the Pin Code has been reset it will be necessary to store a new one. In case the Pin Code is not stored it will not be
possible to start the vehicle without the passive or active key.
Start procedure with passive key or with active key with flat battery.
To start the motorcycle with the passive key, or with the active key with a flat battery, place the key (active or passive) in
contact with the antenna. To reach the antenna remove the seat (Sect. 5 - 3, "Removal of the seat"). While holding the
key in this position, the dashboard may be switch on and the engine started using the standard procedure described
previously. The key may be removed from this position once the engine is running. When the key is removed and the
vehicle speed exceeds 5 Km/h, the no key message will be displayed on the dashboard. This is normal.

Wiring diagram of the Hands Free system

The diagram illustrates the inputs, outputs and communication lines used by the Hands Free system.
1I - ON/OFF button placed on the Hands free system (located below the plastic cover)
2I - ON/OFF button placed on the bike handlebar RH side
3I - Steering position micro-switch
4I - Steering position micro-switch
5I - Active key (signals remote transmission)
6I - Passive key (it transmits signals only if leant on the antenna)
1U - Electric filler plug (optional)
2U - Hands free relay (it replaces the ignition switch function)