Clutch assembly: clutch
The total thickness of the discs pack must not be less than 46.1 mm.
Place the plate on a flat surface and check the amount of deformation with a feeler gauge.
Max. flatness error: 0.2 mm.
Overhaul of the pressure plate
Check bearing (5) condition; renew the bearing if the play is excessive.
Check the contact surfaces of the last friction plate; if extremely scored, polish it in the same manner as described
previously for the cylinder head surface (Sect. 9 - 4.5,
Overhaul of cylinder head
components).
Check conditions of the spring guide bucket tappet (G) of the pressure plate (4) and of the circlips (6).
Overhauling the pressure plate springs
Measure the length "L" of each spring (3).
Minimum length: 41 mm.
Renew any springs that are shorter than the above limit value.
Reassembling the clutch
Position the spacer (13).