Removal Of The Clutch Transmission Unit - Ducati Monster 796 Workshop Manual

Handlebar unit: clutch lever
Operations
Fill the clutch circuit
Refit the LH mirror

Removal of the clutch transmission unit

Warning
The clutch slave cylinder manufacturer advises against servicing of internal components of clutch slave cylinder(23) due to
the safety critical nature of this component.
Incorrect overhaul of these critical safety components can endanger rider and passenger safety.
The only components that should be renewed are the complete clutch transmission unit, the bleed valve, the seals and
the complete clutch pushrod assembly.
Operations
Drain the clutch system
Undo the three screws (15) securing the clutch transmission unit (14) to the engine and withdraw the unit from the
crankcase.
Remove the dust cap (12) and the bleed valve (11) and unscrew the banjo bolt (10), taking care to recover the sealing
washers (8): the unit (14) is now disconnected from hose (6).
Push in the piston to force out all the fluid from inside the cap.
At this point, it is possible to slide also the clutch gear rod (16). Check the wear state of the two O-rings (17) and replace
Section reference
4 - 3, Filling the clutch circuit
5 - 1, Refitting the rear-view mirrors
Section reference
4 - 3, Draining the clutch hydraulic
circuit