Table of Contents
Advertisement
Refitting the front brake master cylinder
Insert the front brake master cylinder unit (3) on the right side of the handlebar so as the clamp internal
edge matches with the mark (A).
Position clamp (6) on the handlebar and start the screws (5).
Tighten the fastening screws (5) to the specified torque of 10 Nm ± 10% following the sequence 1-2-1
starting from the upper screw.
Position the hose (4) and sealing washers (2) on the master cylinder unit (3) and secure with the special
screw (1), without tightening.
Advertisement
Table of Contents
