Activate Diagnostic Messages Via Step 7 - Siemens SINAMICS G120 Operating Instructions Manual

16.If you have installed Drive ES Basic, open the STARTER by double-clicking the inverter
17.If you are working with the GSDML, close HW Config now and create a reference for
You have configured the communication between the inverter and the control unit using
PROFINET .
A.8.3.2

Activate diagnostic messages via STEP 7

Procedure
Proceed as follows to activate the diagnostic messages of the inverter:
1. In HW Config, select the inverter.
Converter with the CU250S-2 Control Unit (vector)
Operating Instructions, 06/2013, FW V4.6, A5E31759476B AB
symbol in the Hardware Manager and configure the inverter in the STARTER.
In this case, STARTER automatically accepts the device name and IP address. The
approach described in the following section is therefore superfluous.
STARTER as described in the following section.
Figure A-10 Highlight inverter in HW Config
Appendix
A.8 Application Examples
443