Changes In This Manual - Siemens SINAMICS G120 Operating Instructions Manual

Changes in this manual

Important changes with respect to the Manual, Edition 01/2013
An overview of all new and modified functions in Firmware V4.6 can be found in section New
and extended functions (Page 411).
Revised descriptions
Updated Order No. of the memory card.
Overview of the permissible motors has been supplemented. Motor series that are supported
SMC and SME Sensor Modules supplemented.
Licensing procedure supplemented.
Converter with the CU250S-2 Control Unit (vector)
Operating Instructions, 06/2013, FW V4.6, A5E31759476B AB
In Chapter
Overview of Control Units (Page 24)
(Page 37)
Installing encoders (Page 66)
Activating licensed functions
(Page 413)
5