Siemens SINAMICS G120 Operating Instructions Manual page 470

Index
Selecting, 230, 231, 420
Shield connection kit, 28
Short-circuit monitoring, 257
Signal cables, 70
Signal interconnection, 430
Signal states, 366
SIMATIC, 438, 439
Sine-wave filter, 34
SIZER, 462
Skip frequency band, 106
SMC (Sensor Module Cabinet), 38, 66
SMC: Sensor Module Cabinet, 66
SME (Sensor Module External), 38, 66
SME: Sensor Module External, 66
Speed
change with BOP-2, 422
Limiting, 235
Speed deviation, 296, 297
Speed monitoring, 296, 297
Square-law characteristic, 245
Stall protection, 294, 295
Star connection (Y), 419
STARTER, 39, 85, 303, 332, 426
Download, 39
STARTER commissioning tool, 303
STARTER PC tool, 303
Starting characteristics
Optimization, 246
State overview, 217
Status word, 124, 127
Status word 1, 126
Status word 3, 128
STEP 7 object manager, 439
STO (Safe Torque Off), 302
Acceptance test, 319
select, 302
Storage medium, 323
STW1 (control word 1), 125
STW3 (control word 3), 127
Subindex, 132, 163
Suggestions for improvement manual, 464
Support, 463
Switch off
Motor, 217
OFF1 command, 217
OFF2 command, 217
OFF3 command, 217
Switch on
Motor, 217
ON command, 217
Switching on inhibited, 125, 218
Switching over units, 260
470
Switching-on a motor with BOP-2, 422
Switch-off signal paths, 310
Symbols, 21
SYNC, 179
System runtime, 368
T
Technical data
Control Unit, 385
Technology controller, 127, 263, 290
Telegram
paste, 115, 118
Telegram types, 439
Temperature monitoring, 255
Temperature sensor, 58, 59, 75
Temperature switch, 256
Terminal block, 64, 95
Terminal strip, 75, 76
Assignment, 75
Overview, 58
Test signals, 308
Three-wire control, 219
Time slices, 300
TN-C system, 52
TN-C-S system, 52
TN-S system, 52
Torque monitoring
Speed-dependent, 294, 295
TPDO, 184
Trace function, 427
TT system, 52
Two-wire control, 219
Type plate
Control Unit, 23
Power Module, 23
U
U/f control, 242, 421
UL, 397
Unit system, 262
Unwinders, 277
Up ramp, 420
Update (firmware), 315
Upgrading the firmware, 358
Upload, 326, 332, 334
USB cable, 39
USB interface, 86
Use for the intended purpose, 15
User interfaces, 56
Converter with the CU250S-2 Control Unit (vector)
Operating Instructions, 06/2013, FW V4.6, A5E31759476B AB