Procedure
Proceed as follows to connect the Brake Relay with the inverter:
1. Connect the Brake Relay to the Power Module using the cable form provided.
2. Connect the motor holding brake to the terminals of the Brake Relay.
You have connected the Brake Relay with the inverter.
Converter with the CU250S-2 Control Unit (vector)
Operating Instructions, 06/2013, FW V4.6, A5E31759476B AB
Power Modules FSA ... FSC
Connect the Brake Relay at the connector
•
on the front of the Power Module.
Route the control cable in the guide on the
•
Power Module.
8.7 Application-specific functions
Power Modules FSD ... FSF
Connect the Brake Relay at the connector on the
lower side of the Power Module.
Setting functions
279