Activate Diagnostic Messages Via Step 7 - Siemens SINAMICS G110M Function Manual
Fieldbuses
Hide thumbs
Also See for SINAMICS G110M:
- Operating instructions manual (428 pages) ,
- Original instructions manual (344 pages) ,
- Function manual (244 pages)
Table of Contents
Advertisement
A.1.2.2
Activate diagnostic messages via STEP 7
Procedure
Proceed as follows to activate the diagnostic messages of the inverter:
1. In HW Config, select the inverter.
Image A-1
2. By double clicking on slot 0 in the station window, open the property window for the
inverter's network settings.
3. Select the Parameters tab.
4. Activate the standard alarms.
You have activated the diagnosis messages.
With the next ramp-up of the controller, the diagnostic messages of the inverter are then
transferred to the controller.
Fieldbuses
Function Manual, 01/2016, FW V4.7 SP6, A5E34229197B AC
Highlight inverter in HW Config
Appendix
A.1 Communication with STEP7
221
Advertisement
Table of Contents
