Siemens SINAMICS G120 Operating Instructions Manual page 133

Parameter number
0000 ... 1999
2000 ... 3999
6000 ... 7999
8000 ... 9999
10000 ... 11999
20000 ... 21999
30000 ... 31999
60000 ... 61999
Indexed parameters
For indexed parameters, you must write the index as hex value into the subindex (IND
bit 15 ... 8).
Parameter contents
Parameter contents can be parameter values or connector parameters. For interconnecting
connector parameters please see section: Interconnecting signals in the inverter (Page 430).
Enter the parameter value, right-justified, as follows in the 4th word of the parameter
channel:
• 8-bit values:
• 16-bit values: 4. Word, bits 0 ... 15,
• 32-bit values: 3. and 4th word
Enter a connector parameter as follows:
• Number of the connector parameter:
• Drive object of the connector parameter:
• The index or bit field number of the connector parameter: 4. Word, bits 0 ... 9
Converter with the CU250S-2 Control Unit (vector)
Operating Instructions, 06/2013, FW V4.6, A5E31759476B AB
7.4 PROFIdrive profile for PROFIBUS and PROFINET
Offset Page index
Hex Bit 7
0 0 hex 0
2000 80 hex 1
6000 90 hex 1
8000 20 hex 0
10000 A0 hex 1
20000 50 hex 0
30000 F0 hex 1
60000 74 hex 0
4. Word, bit 0 ... 7,
bits 8 ... 15 of the 4th word and the 3rd word are zero.
The 3rd word is zero.
Bit 6 Bit 5 Bit 4 Bit 3
0 0 0
0 0 0
0 0 1
0 1 0
0 1 0
1 0 1
1 1 1
1 1 1
3. Word
4. Word, bits 10 ... 15
Configuring the fieldbus
Bit 2 Bit 1 Bit 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 1 0 0
133